Solar Savings Calculator: Years to Pay Back Your Investment by State

Calculate how many years your panels take to pay for themselves and compare 41 states and Washington, D.C.

Installation cost Recovered

The time it takes solar to pay for itself depends on three numbers: what the system costs, what it produces and what each kWh is worth on your bill. With the calculator on this page you can get your own figure in a minute. Below you will find a payback comparison by state.

Solar savings and payback calculator

Estimated net cost–
Estimated first-year savings–
Years to pay back the investment–

The starting values (production, electricity price and 100%) are only an example. Replace them with the ones from your quote and your bill. The system cost is your state’s average price per watt according to EnergySage (November 2026).

How the payback period is calculated

Net costsystem price minus incentives
÷
Annual savingskWh produced × electricity price
=
Years to pay backthe investment

An example with round numbers: an 8 kW system in Texas, at the average price of $2.26 per watt, costs $18,080. If it produces 10,000 kWh a year and each kWh saves you $0.16, you save $1,600 a year. Then $18,080 ÷ $1,600 = 11.3 years. The production and electricity price in this example are assumptions to illustrate the math, not Texas data.

The calculator does the same, but lets you change the other variables. If you enter an annual electricity price increase, the savings grow each year and the payback period gets shorter. With 0% the calculation is the most conservative.

Years to pay back the investment by state

The states with the shortest paybackWashington, D.C.5.6 years Illinois5.8 years California7.3 years Massachusetts7.8 years Connecticut8.8 years New Jersey8.8 yearsThe states with the longest paybackUtah28.1 years Tennessee20.8 years Washington20.2 years Idaho19.8 years Louisiana19.4 years
The states with the shortest and longest payback periods, without the federal credit. Source: EnergySage, July 2025.

How to read this comparison.

  • These are EnergySage estimates published in July 2025, before the federal credit ended. The “no credit” figure is its calculation of the current scenario.
  • EnergySage does not explain the method (system size, electricity prices or production), so it is useful for comparing states with each other, not for predicting your own payback period.
  • EnergySage sells solar installations, so it is wise to check against your own quotes.
StateYears to pay back the investment (no federal credit)
Washington, D.C.5.6 years
Illinois5.8 years
California7.3 years
Massachusetts7.8 years
Connecticut8.8 years
New Jersey8.8 years
Texas8.9 years
Nevada9.0 years
Rhode Island9.7 years
Pennsylvania10.1 years
New Hampshire11.4 years
Ohio11.4 years
Maryland11.5 years
New York11.6 years
Delaware12.2 years
South Carolina12.6 years
Virginia12.7 years
Oregon13.4 years
Oklahoma14.2 years
North Carolina14.6 years
New Mexico14.6 years
Wisconsin14.6 years
West Virginia15.0 years
Vermont15.1 years
Minnesota15.3 years
Arkansas15.5 years
Florida15.5 years
Arizona15.7 years
Colorado16.1 years
Missouri16.9 years
Maine17.3 years
Georgia17.6 years
Kansas17.8 years
Michigan17.9 years
Kentucky18.2 years
Indiana18.9 years
Iowa18.9 years
Louisiana19.4 years
Idaho19.8 years
Washington20.2 years
Tennessee20.8 years
Utah28.1 years

Source: EnergySage, solar payback periods without the tax credit, updated in July 2025. Alabama, Alaska, North Dakota, South Dakota, Nebraska, Mississippi, Montana, Hawaii and Wyoming are missing because they do not appear in that table.

What happens when one number changes

Take the example above: an 8 kW system costing $18,080 and producing 10,000 kWh a year, which pays back in 11.3 years when each kWh saves $0.16. Change only the value of a kWh and the picture moves. At $0.20, savings are $2,000 a year and payback falls to about 9 years. At $0.12, savings are $1,200 and payback rises to about 15 years. That is why EnergySage says paybacks stretch out when electricity costs less than 10 cents per kWh, and why high-price states look so good in the table. Our state electricity price table shows where your rate sits.

Why some states pay back in half the time

Look at the table: Florida and Arizona, two very sunny states, take about 15.5 and 15.7 years. Illinois, with less sun, shows 5.8. The conclusion is that sun does not explain everything. The source does not detail the causes, but these are the factors that move the result in any state:

Electricity price

Each kWh saved is worth more or less

Where electricity is more expensive, the same production saves more money. EnergySage points out that below 10 cents per kWh the payback period gets much longer.

Incentives

Local incentives

Tax credits, rebates or renewable energy certificates from your state or utility shorten the payback period.

Check them at DSIRE.

Compensation

What you are paid for the energy you send to the grid

Compensation rules (net metering) vary between states and utilities and directly affect your savings.

Cost and sun

Price per watt and production

A system that is cheaper per watt and produces more pays for itself sooner. You can find the average price by state in our cost calculator.

What a simple payback leaves out

Payback is a useful first filter, not a full financial analysis. A system that pays back in 9 years and lasts 25 or more can still be a good investment, and one that takes 18 may not be, but your own numbers decide.

How to refine your estimate in four steps

  1. Ask your installer for the estimated annual production in kWh. You can also check it with the free tool PVWatts from the NREL laboratory.
  2. Work out your electricity price: divide the energy charge on your bill by the kWh used.
  3. Ask your utility how it credits the energy you send to the grid and adjust the percentage in the calculator.
  4. Subtract incentives from your state, city or utility and compare the result with the years you plan to live in the house.
Does the calculator include the federal credit?

No, because the credit ended for systems placed in service after 2025. If you have a state or utility incentive, enter it in the calculator.

Why does my installer’s number differ from this one?

Installers use your own production estimate, shading, roof and price. Ask them what price increase and degradation they assume, and compare with the 0% case in the calculator, which is the most conservative.

Is solar still worth it?

It depends on your electricity price, sun and incentives. Our article on solar without the federal tax credit looks at that question.

How to use this page

Use the table to see how your state compares, then replace its assumptions with yours: your price per kWh, your production estimate and your quote. If the result is a payback well within the life of the panels, solar probably makes sense. If it is close to the limit, test it with a lower electricity price and no price increases, and compare with other uses of the same money. A calculator is a way to ask better questions of your installer, not a substitute for a quote.

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top