Generator Size Calculator: What Power Do You Need?

Fridge+ 2,200Pump+ 2,000Heating+ 1,400 = kW Running watts and the largest starting load are added

To know what generator you need, add up the running watts of everything you want to use at the same time and add the largest starting load of a single appliance; then leave a margin so you do not go past 90% of capacity. It is the method given by Bob Vila and Home Depot, and the calculator does it for you with the most common appliances.

Running + startingAdd what you use at once and the largest start-up of one
90%Maximum share of capacity it is wise to use (Bob Vila, Home Depot)
3 timesApproximate motor start-up, according to Home Depot
7.5 to 25 kWSizes that Bob Vila relates to small through large homes

What generator power do you need?

Enter how many of each appliance you want to power at once during an outage.

ApplianceQuantity
Refrigerator/freezer
Furnace fan (1/3 HP)
Well pump (1/3 HP)
Sump pump (1/2 HP)
Window A/C (12,000 BTU)
Central A/C
Electric water heater
Electric range or oven
Electric space heater
Microwave (1,000 W)
Coffee maker
Television
Computer with monitor
Running watts–
Largest additional starting load–
Minimum recommended generator–

Our own calculation with data from an eweb.org document (undated) and from Bob Vila and Home Depot. Formula: running watts of everything you use at once + the largest additional starting load of a single appliance; then divide by 0.9 so you do not exceed 90% of capacity, a rule given by Bob Vila and Home Depot. Central air conditioning has no starting load in the sources: it is estimated as 3 times its consumption, Home Depot’s rule for motors. The actual values are on your appliance’s label or manual.

The formula, step by step

  1. Make a list of what you want to power at the same time in an outage.
  2. Find the running watts of each appliance on its label or manual.
  3. Add them all up.
  4. Pick the appliance with the largest starting load and add only that starting load to the total (Bob Vila and the eweb.org document).
  5. Divide the result by 0.9 to stay at 90% of capacity.

Bob Vila’s example: 3,000 running watts plus 1,500 W of the largest starting load gives at least 4,500 W; with the 90% margin, it would be about 5,000 W. The page itself does not apply that margin in the example.

Running watts and starting watts, in plain words

Motors, such as a refrigerator compressor or an air conditioner, need a burst of power when they start. Home Depot says that start-up is about three times the running load. The generator has to survive that burst, not just the steady draw, which is why the formula adds the largest single starting load.

An example using numbers from this page

Say you want a refrigerator (800 W, the top of the 600 to 800 W range), a microwave (1,200 W) and a television (350 W) running at the same time. That is 2,350 running watts. The refrigerator also has the largest start-up, about three times its running load, or 2,400 W. Following the formula above:

2,350 Wrunning
+
2,400 Wlargest start-up
÷
0.9margin
=
≈ 5,300 Wminimum size

This is an illustration, not a purchase recommendation. Your appliances have their own labels, and the load for a window or central air conditioner raises the total a lot: the table in this article shows a window unit demanding 7,200 W at start-up.

How much common appliances need

Watts each appliance needs: running and additional startingRunningAdditional start-up03,0006,0009,000Electric water heater4,500 WWindow A/C 12,000 BTU7,200 WElectric space heater1,500 WSump pump 1/2 HP3,250 WWell pump 1/3 HP3,000 WFurnace fan 1/3 HP2,100 WRefrigerator/freezer2,900 W
Data from an eweb.org document, with no visible date or author. For the window A/C, the start-up raises the demand to 7,200 W.

Sources: eweb.org: considerations for sizing a generator, Bob Vila (published October 22, 2021, modified November 18, 2024) and Home Depot (May 19, 2025, a retailer).

Other running loads cited by Bob Vila and Home Depot: central air conditioning 2,000 to 4,000 W, electric range or oven 5,000 W, water heater 3,000 to 4,500 W, microwave 1,200 W, refrigerator 600 to 800 W and television 100 to 350 W. No list gives the starting loads of all appliances.

What size usually fits each home

GeneratorAir conditionerBathroomsBedroomsWater heaterOffice and garage
7,500 W2 tons11NoNo
10,000 W3 tons12YesNo
18,000 W5 tons35YesYes
25,000 W5 tons3 or more5 or moreYesYes

Source: Bob Vila. All sizes power the kitchen, heating, sump pump and common areas. The page contradicts itself: it marks the 7,500 W generator as able to power an electric oven, which it itself puts at 5,000 to 25,000 W.

Sort your loads into three tiers

Tier 1

Must run

Refrigerator, medical devices, a few lights, a phone charger, a furnace fan or well pump if you depend on them.

Tier 2

Strongly wanted

Sump pump, internet router, a window air conditioner for one room, a microwave.

Tier 3

Nice to have

Central air, electric range, electric water heater, dryer. These are the ones that push the size up.

Start with tier 1 and add upward until the cost makes you stop. Most of the difference between a small and a very large generator is tier 3.

Safety

Never run a generator inside a garage, a house or any enclosed structure, even with doors or windows open: carbon monoxide is dangerous and hard to detect. Home Depot also recommends using a circuit breaker to prevent overloads. Have a licensed electrician install the connection to the house.

When to move from “essentials” to “whole house”

If you only want a refrigerator, lights, heating and a pump, a small generator may be enough. If you want central air conditioning, an electric water heater and an electric range at the same time, the sum shoots up. In that case, compare the cost of a whole-house generator with that of protecting only the essentials, and consult an installer.

To see how much a whole-house generator costs, see our generator cost calculator.

Too small, too large

A generator that is too small trips under load or struggles, and running it at the limit for hours is hard on the engine. One that is far too large costs more to buy and burns more fuel for the same work. That is why the 90% margin is useful in both directions: it keeps you under the limit without inviting you to oversize.

Do I need an inverter generator?

They produce cleaner power, which is better for electronics, and many are quieter. For a few essentials they are a popular choice, while large loads usually point to conventional or standby units.

Can I plug the generator into a wall outlet?

No. Back-feeding the house is dangerous for you and for utility workers. Use a properly installed transfer switch or interlock, and, as Home Depot recommends, protect circuits with a breaker. Hire a licensed electrician.

Is square footage a good way to size it?

It is a starting point at best. Angi sizes by what you want to power, which we think is more reliable than square footage.

Keep in mind that the sources here are a mix: a magazine article, a retailer and an undated document from a utility-linked site, and they do not list starting loads for every appliance. For anything that matters, such as medical equipment or a well pump, read the label or manual of that specific device and ask the installer to confirm the numbers. A written load list that you bring to the first quote will save time and avoid being sold a larger machine than you need.

Once you know your number, see what it costs to buy and install in the whole-house generator cost calculator, and check what it costs per hour to run.

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top